Simplified Software Updates
Both INVICTA and MIRUS software can be upgraded without use of a computer or any installer program on the computer.
The systems have the ability to replace their own installed software from a file on the SD Card in its own SD Card slot.
The update file is the same for INVICTA and MIRUS: the software detects the product type and installs the appropriate code.
Most files on the SD Card inserted to INVICTA and MIRUS will, of course, be music files.
But certain file types, (specifically *.bin files) are interpreted as sources for software updates.
The procedure for software updates therefore begins by copying the software update file that you
have downloaded from the WWW to an SD Card and navigating to that file with the front panel controls.
Initiating ‘playback’ of the software update file will seamlessly install the new upgrade on your INVICTA or MIRUS.
The latest Software Release is 6.2.2
Important: HDMI output should be disabled prior to the upgrade process. [How do I do this?]
Note: You must have firmware version 5.2.2 or 6.2.0 (or newer) installed prior to upgrading to 6.2.2
[see the note below "If you would like to confirm your serial number and software version" to check this]
Available Now (June 2014):
Downloading and Installing
Release 6.2.2 adds the following features:
Release 6.2.1 adds the following features:
Release 6.2.0 adds the following features:
The upgrade procedure will then take place, you will see the actions “Erasing Software”, “Applying Upgrade”, “Writing USB firmware ” and finally, “Upgrade Complete Please Cycle Power”
At this point turn off the power, and after a few seconds, turn it on again. INVICTA/MIRUS will now boot with the new software.
If you would like to confirm your serial number and software version: